Prototype Photographs

October 2004.  Photographs of the SnapEasy(tm) Original system prior to review by General Binding Corporation.  Several of the unique features of this device are showcased in these photographs.

MVC-001F.JPG (132035 bytes) MVC-002F.JPG (129217 bytes) MVC-003F.JPG (131745 bytes) MVC-004F.JPG (133139 bytes) MVC-005F.JPG (47688 bytes)

 MVC-006F.JPG (54638 bytes) MVC-007F.JPG (41691 bytes) MVC-008F.JPG (126791 bytes) MVC-010F.JPG (137251 bytes)

Original Binder Prototype

November 19, 2001.  Photographs show SnapEasy(tm) Binding "Original" system in two "open" configurations and three "engaged" configurations.  The open photos demonstrate the ring piece tabs and engagement notches, and the spine piece receiving slots.  The closed photos show the ring piece partially engaged in the spine piece.  The ring piece has not been fully engaged into the spine slot notches because this system is the mold "blank" pieces and engaging the notches may have caused damage to the blank.

open1.jpg (52817 bytes) open2.jpg (76018 bytes) closed1.jpg (90333 bytes) closed2.jpg (69090 bytes) closed3.jpg (62706 bytes)

System Features

snap-easy-binding-method.jpg (125607 bytes) click-it-binding-method.jpg (125415 bytes) 

        

Get in on the next generation of business and personal use binding systems.

The evolution of the SnapEasy(tm) Binding System into a commercially-viable, standard three-ring hole punched paper system.

 fig2.jpg (92762 bytes)

Hit Counter